I've used the file simple-evse1.1_modbus_rev18.X.production.unified.hex
All went fine (see attached log), BUT using the same SimpleEVSE WIFI v1.1.1 module I get now Modbus error in the interface.
I have a feeling that is the wrong FW (for the controller with Modbus HW Module).
P.S. The car is charging...
*****************************************************
Connecting to MPLAB PICkit 4...
Currently loaded versions:
Application version............00.06.87
Boot version...................01.00.00
Script version.................00.04.57
Script build number............f33c871d94
Tool pack version .............1.9.1163
Connecting to MPLAB PICkit 4...
Currently loaded versions:
Boot version...................01.00.00
Updating firmware application...
Connecting to MPLAB PICkit 4...
Currently loaded versions:
Application version............00.06.88
Boot version...................01.00.00
Script version.................00.04.57
Script build number............f33c871d94
Tool pack version .............1.9.1163
PICkit 4 is supplying power to the target (2,38 volts).
Target device PIC16F1825 found.
Device Revision Id = 0x4
Loading code from-------\simple-evse1.1_modbus_rev18.X.production.unified.hex...
2021-10-04 10:50:13 +0300 - Hex file loaded successfully.
2021-10-04 10:50:29 +0300 - Programming...
*****************************************************
Calculating memory ranges for operation...
Erasing...
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x3bf
program memory: start address = 0x400, end address = 0xfff
program memory: start address = 0x1580, end address = 0x17ff
configuration memory
Programming/Verify complete
2021-10-04 10:50:34 +0300 - Programming complete